 |
POLAR STAR FUSION ENGINE V2 GEN 3Features:- FE Profile: Version 2
- Included FE Nozzle Type: M4/M16 Series, Blue (FE-NZ-BLU-M4)
- Included Selector Plate: M4/M16 Series
- Cyclic Rate: 500 RPM to 1,800 RPM - Fully adjustable
- Fire Modes: Semi / 2 to 9 Shot Burst, Semi / Full Auto, Semi Only
- Power Source: HPA (High Pressure Air via remote air rig)
- FCU Battery: 7.4v LiPO or 9.6 NiMh
- FCU Voltage Input Range: 6.8v to 12v
- PSI Operating Range From 90~120 psi
- Electronics: REV2
- PSI Operating Range: 80 psi. to 120 psi
- Build Material: Aluminum
- Internally Compatible with V2 REV2 Fusion Engine
- Compatible with standard TM M4, M16, G3, MP5, and SCAR airsoft AEGs.
Description:
The new Version 2 Gen 3 Fusion Engine from Polar Star is one of the most efficient and effective operating systems in airsoft today. This new version comes equipped with an easy to remove selector plate so you can run regular AEG selector plates so you can easily install your Fusion Engine in an MP5, G3, or scar. It is currently set up with an M4/M16 metal selector plate (VFC). This kit will come with the REV2 Fire Control Unit (FCU). This allows you to easily tune your Polar Star based on your performance standards and allows you to have your system operating in the most efficient manner in your gun. These systems extremely easy to set up and use, however as always professional installation is highly recommended. Polar Star also offers a wide variety of color coated nozzles giving so you can further get the velocity you desire.
This Fusion Engine comes with the Blue nozzle pre-installed:
BLUE: 380fps with 275mm Barrel, 405fps with 380mm Barrel, 435fps with 509mm Barrel.
CQB
(275mm) = 380fps, Carbine (380mm) = 405fps, Rifle (509mm) = 435fps -
See more at:
http://polarstarairsoft.com/products/fusion-engine-nozzles/m4-m16-series-nozzles/fusion-engine-m4-m16-nozzle-blue.html#sthash.bjgGmnrL.dpuf
Warning: We at AirRattle.com recommend all upgrade / repair parts are installed by a professional as additional upgrades and/or custom fitting may be required. It is the responsibility of the customer to ensure the part is compatible with their gun prior to purchase. We are not responsible for any damage caused during or after installation and are installed at customer�s discretion.
|
|
|
Good Job 
